Octave fuzz problem

CfrenchFCI · **Joined:** Sun Jan 15, 2012 1:37 pm **Posts:** 11

I had this working Saturday night and yesterday but I was just playing it and te effect started cutting in and out. Any tips on where to look first?

duhvoodooman · **Posted:** Mon Jan 23, 2012 7:05 pm

Start with your soldering quality. Signal cutting in and out is almost always a bad connection somewhere. The wire connections are most prone to problems, then the component connections on the PCB. A good first step is to go through the entire build and re-flow EVERY solder joint. Should only take maybe 20 minutes and often solves problems like the one you describe. If that doesn't do the trick, we'll need to see photos: viewtopic.php?f=51&t=6108

CfrenchFCI · **Joined:** Sun Jan 15, 2012 1:37 pm **Posts:** 11

Great thanks for the quick response.

Build Your Own Clone Message Board

Octave fuzz problem

Who is online