Build Your Own Clone Message Board

So I built the AMZ mini boost and I ran it into my Randall Rx20R. I turned the pedal all the way up and got this amazing distortion sound that I loved. Unfortunately, now my amp is behaving strangely. It won't respond at all until I turn the channel volume all the way up, and then it will cut out if I do anything with dynamics(Like a badly bisased fuzzbox). It has two channels, a clean and a distortion, and both exhibit this behavior. Is it possible that the boost fried my amp? In the interest of full disclosure, I had also modified the amp to allow foot-switchable spring reverb, but that worked fine until I brought the boost into the picture. The amp uses a lm1875 power amp, a tl072 for each channel, and a 4558 amp for the reverb. Is it dead?