Build Your Own Clone Message Board

I just assembled my very first BYOC pedal.

As i feared i is not functioning

The leds can be turned on and off, but it's like no signal is running through the pedal. Even in true bypass there is no sound.

I checked my soldering and went through the setup again and again.

Unfortunately i only have a shitty camera on my cell, so i want be able to post pictures before my parents come visiting with their camera.


Any ideas of what i did wrong?

In most cases the reason a build doesn't work upon completion is poor soldering. Having good soldering skills is absolutely crucial if you want to have a working pedal when you're done. I would say the next most common error is misplaced components.

If your camera isn't the best try borrowing one. You would be surprised at the number of times a fresh set of eyes will find a build error that you looked at 100 times and didn't notice.

I will put up pictures ASAP